| KDK Tool Posts usually require a riser plate between
the Tool Post and the lathe compound to bring tool to lathe center
height. A riser plate, up to 1-1/8" thick will be furnished FREE if
you specify the lathe center height. See Dimension "A". Special
riser plates thicker than 1-1/8" can be made at time and material
cost. NOTE: T-Nuts are not standard for all lathes. To insure
correct size, furnish T-Slot Dimensions A, B, C, D, E from drawing
and specify the make and model of lathe.
Click here for a printable form you can fill out and fax to us
at: (800) 779-8188 or (928) 556-3048. |
 |
